Your question: What does a Power Commander do for your bike?

What is a Power Commander? The Power Commander is a fuel injection and, on some models, an ignition timing adjustment unit that plugs ‘inline’ with the bike’s stock ECU (Electronic Control Unit). … Simply removing the Power Commander unit returns the bike to its previous stock condition.

Is a Power Commander bad for your bike?

Power Commanders do not harm your bike. They don’t “trick” the OEM ECU. It is nothing more than a piggyback ECU.

What’s the purpose of a Power Commander on a motorcycle?

A Power Commander is a brand of fuel injection or ignition timing manufactured by Dynojet Research Inc. The Power Commander is used by motorcycles as a way of boosting their engine performance to a higher level of horsepower than a rider might get from the motorcycle’s stock engine performance.

Does a Power Commander increase horsepower?

Just adding a Power Commander to a completely stock vehicle usually does not increase peak horsepower. It usually will improve drivability, throttle response, and mid-range horsepower and torque. … This will often give an increase in overall horsepower.

Do you need to dyno tune a power commander?

yes you need a powercommander for a dyno tune. That is what they tune that controls how much fuel is pumped into your engine. You also should install block off plates. It may help with some of the popping as well.

IT IS INTERESTING:  Can you ride a hybrid bike on mountain bike trails?

How much does a power commander cost?

Compare with similar items

This item Dynojet (19-001 Power Commander V Fuel Injection Module Dynojet (14-019 Power Commander V Fuel Injection Module
Add to Cart Add to Cart
Customer Rating 5.0 out of 5 stars (1) (0)
Price $39999 $34999
Sold By Racing Performance Racing Performance

What does a Power Commander 5 do on a motorcycle?

The Power Commander V is a unique EFI tuning device because it can monitor and maintain your air/fuel ratio without directly changing the ECU. To reinstate your stock settings, all you need to do is uninstall the device, and you’re done.

How do you tune a motorcycle with a Power Commander?

Hold down all three buttons on the face of the Power Commander unit and turn on the bike’s ignition. Release all the buttons once the engine is idling normally. The Power Commander manual recommends waiting approximately 20 seconds before making any adjustments.

Where can I download Power Commander maps?

To install a map on a Power Commander V fuel tuner, you will need to download the Dynojet Power Commander software using a Windows computer (or a Mac running Windows). Once you install the software, it is easy to download maps from the Dynojet.com website.

Can Power Commander be used on different bikes?

Life Member. Yes, you can move your PCV to the other bike as both bikes use the same one (Part # 15-011). You will however need to go to the Power Commander website and download a new map to the PCV that matches your current setup for the 2012.

How do I install power commander?

How to… fit a power commander

  1. Position the commander. Find somewhere protected from rain and engine heat to mount the power commander. …
  2. Connect to the battery. The power commander has one black 12v connector, which goes onto the black negative battery terminal. …
  3. Connect to the injectors. …
  4. Check and start the bike.
IT IS INTERESTING:  Are all bike stems the same diameter?

How much is a power commander for a motorcycle?

Regular: $384.99 – $604.99 Save 10%!